![]() ![]() ![]() Yeah i sent some nasty grams to tech support. So impossible basically in current setup. But to get a good cut it needs to be about 8mm at most. Well the problem with that is the closest i can get the materials to the nozzle is about 112mm. Problem number two is that omtech sold me this table with the specific feature of "dual passthrough doors" so you can put pieces in larger than the cutting area. What i realized pretty quick was the wood was not the same thickness or was raised slightly and so i couldn't set my cutting depth the same for the whole table. So i go to do a full table cut and the right half of the table looks like garbage on top, tons of shadow burns around the cuts, and the bottom almost doesn't even cut thru in most spots on the right. It looks amazing, no burning on top, cuts cleanly thru on the bottom. Basically what has been happening is i will do some smaller test cuts on the left side of the table. So after a very frustrating start to "lasering" this weekend i finally discovered a fundamental thing and i have a much better understanding of the different issues i have been experiencing lately.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |